Dexter Electric over Hydraulic Actuator for Disk Brakes


Electro/Hydraulic brake actuator provides 1600 psi of pressure for 1-3 axles equipped with disc brakes. Brake fluid pressure is proportional to the electronic brake controller signal. Sealed, anodized aluminum housing provides a weather tight seal. Two year limited warranty.

  • 1,000 psi maximum pressure output for axles equipped with drum brakes (K71-650-00)
  • 1,600 psi maximum pressure output for axles equipped with disc brakes (K71-651-00)
  • Dimensions: 11.38" long x 6" wide x 7" high
  • Requires a four wire hookup and minimum 9 amp/hour break-away kit
  • Uses DOT 3 or 4 brake fluid holds 40 cubic inches (0.7 quarts) of fluid
  • Meets all DOT regulations and complies with CFR-393 federal braking requirements, as opposed to surge brakes
  • Eliminates the feeling of being "pushed" by the trailer (reducing the potential of jackknife)
  • Eliminates the problems found when backing a trailer uphill with surge brakes
  • Eliminates brake drag common with surge brakes on a downhill grade

Product Brochure

Add to Cart:

  • Model: K71-651-00
  • Manufactured by: Dexter

Your IP Address is:
©2007 Web Design by Gray Graphics